What should I do if there are air holes in the finished injection molding?

November 12, 2021

In the injection molding process, sometimes there are many small bubbles of the finished product, not only impact strength and mechanical properties of the finished injection molding, the appearance of the finished product price values are also greatly reduced, so when bubbles are finished, several factors can be checked, and Do the processing.

Usually, when the thickness of the finished product is different, or when the mold has protruding ribs, the cooling speed of the plastic in the mold is different, the degree of shrinkage is different, and bubbles are easily formed, so special attention must be paid to the design of the mold.

In the use of raw materials, if the plastic with moisture, in the melting of the plastic after the decomposition of the rubber, the tolerance of the injection screw is too small, the air easily enters the cavity to form bubbles, the following is the possible causes and treatment.

Different degrees of shrinkage easily form bubbles

Nous contalit

Auteur:

Ms. He Lichun

Phone/WhatsApp:

+8613906114773

Produits populaires

Actualités

Analyse de six facteurs importants dans le moulage par injection

September 27, 2022

Vous pouvez aussi aimer

Catégories connexes

Envoyer à ce fournisseur

Sujet:

E-mail :

message:

Votre message MSS

Nous contalit

Auteur:

Ms. He Lichun

Phone/WhatsApp:

+8613906114773

Produits populaires

Actualités

Analyse de six facteurs importants dans le moulage par injection

September 27, 2022

Blog News

Two-component injection molding new equipment available

December 02, 2021

Telling about the injection molding process of crystalline plastics

November 03, 2021